T+A PA 3100 HV Integrated Amplifier

AED 85,000.00

  • HV series modules: discrete, shielded, MM module (eight sensitivity levels, sixteen capacitance options), MC module (eight sensitivity levels, sixteen impedance options).
  • PA 3100 HV: VU meters, revised pre-amplifier, redesigned mains section; compatible with PS 3000 HV; optional phono pre-amplifier modules; F3001 remote control included.
  • RMS output: 300W (8 Ohms), 500W (4 Ohms); Peak output: 380W (8 Ohms), 700W (4 Ohms); Frequency response: 0.5 Hz – 180 kHz; THD < 0.03%, SNR > 115 dB.
  • Reservoir capacity: 120,000 µF; Power bandwidth: 1 Hz – 150 kHz.

These modules were specially developed for installation in our HV series of integrated amplifiers and pre-amplifiers. For this reason they are relatively large and feature very sophisticated circuit components, as they are of discrete, channel-separate construction. The metal case provides additional shielding and excellent measured values.
The input sensitivity of the MM module can be set to any of eight levels, in each case with or without sub-sonic filter. Sixteen input capacitance values are available.

The input sensitivity of the MC module can also be set to any of eight levels, in each case with or without sub-sonic filter. Sixteen input impedance levels are available.

MM
Input sensitivity 1,0 up to >10,0 mV
Input capacitance 70 up to 460 pF
MC
Input sensitivity 100 up to >1200 µV
Input impedance 55 up to 1000 Ohm

The Integrated Amplifier

The PA 3100 HV is a further development of the PA 3000 HV, and most of its sub-assemblies are identical. The immediately obvious difference is the pair of VU meters in the front panel, which display the power generated per channel in logarithmic form in Watts into 4 Ohms. A revision of the pre-amplifier section (D.C. coupling) has brought an additional improvement in sound quality.
A further development is the redesigned analogue mains section and voltage power supply, which is similar to that of the A 3000 HV. This makes it possible to connect the supplementary PS 3000 HV mains section in order to gain a further increase in stability and performance of the power supply system as a whole. The additional unit provides an extra 1800 Watt of supply power, enabling the system to control even the most difficult loudspeakers without effort, so that they can unfold the best possible sound quality.

As an option the PA 3000 HV and PA 3100 HV can also be fitted with High-End phono pre-amplifier modules which feature different circuit topologies to suit MM or MC systems. It is also possible to install the analogue signal processor module which has been developed for the P 3000 HV to provide channel-separate tone and loudness functions.
The all-metal F3001 infra-red remote control handset is supplied as standard

RMS output per channel into 8 Ohms
300 Watts

RMS output per channel into 4 Ohms
500 Watts

Peak output into 8 Ohms
380 Watts

Peak output into 4 Ohms
700 Watts

Frequency response + 0 / – 3 dB
0,5 Hz – 180 kHz

Slew rate
60 V/µs

Damping factor
> 65

Signal / noise ratio
> 115 dB

Total harmonic distortion
< 0,03 %

Reservoir capacity
120000 µF

Power bandwith
1 Hz – 150 kHz

Please note that although we endeavour to ensure that the product information displayed on our website is accurate and up to date, Products and their ingredients are liable to change. Due to this, You should always read the label before consuming or using the product and never rely solely on the information presented here. If You require information or have any queries regarding a Grano Organic Own Label product, please contact our Customer Care team. This information is supplied for personal use only and may not be reproduced in any way without the prior consent of Grano Organic and ackowledgement.